Joke carbide coating device for robust surfaces
The Eneska Rapidcoat carbide coating device from Joke Technology is used for the quick and easy coating of particularly stressed surfaces by applying a carbide layer.
Joke Technology's carbide coating process is particularly suitable for tools, molds or general surfaces that need to be particularly tough, hard and wear-resistant, e.g. for punching or bending tools. In addition to these classic applications, the process is also suitable for producing a wear-resistant, rough surface. This can be used to improve the adhesive and holding properties, e.g. for grippers, gripper and clamping jaws etc. or for sliding surfaces, e.g. to improve the adhesion of an oil film. Parts of the friction surfaces of a mechanical guide can also be coated in order to compensate for dimensional deviations caused by abrasion.
Carbide coating as a heat-resistant protective surface layer
In addition, the carbide coating can also be used to create a heat-resistant protective layer, e.g. to protect molds in die casting, and also for coatings on forging molds to significantly extend the service life of tools. Compared to conventional devices, the Eneska Rapidcoat achieves an extremely clean and homogeneous coating in just one operation. The very simple operation is unique. The three interdependent working parameters can be called up quickly and set in predefined stages using the central rotary pushbutton.